Aukru HC-05 Wireless-Bluetooth-Host Serial-Transceiver-Modul Slave und Master RS232 mit 6 set kabel für ArduinoElektronik
the module parameters:
1. P C B Dimensions: 37. 3mm (length) * 15. 5mm ( W)
2. Weight: 3. 5g
3. Input voltage: 3. 6 V - 6 V, 7 V prohibit over
4. Power anti-reverse, reverse module does not work
5. leads to 6 pin: E N / V C C / G N D / R X D / T X D / S T A T E ( Bluetooth status leads to the foot, is not connected to the output low, output high after the connection)
6. En status indicator, L E D flash means no Bluetooth connection; L E D slow flash indicates into the A T command mode
7. On-board 3. 3 V regulator chip, the input voltage D C 3. 6 V-6 V; when unpaired, current is about 30m A (because L E D lights flashing, the current state of change); After the pairing is successful, the current is about 10m A
8. Level interface 3. 3 V, you can directly connect a variety of microcontroller ( Arduino / 51 / A V R / P I C / A R M / M S P430, etc. ), 5 V microcontroller can also be directly connected. Directly connected to the microcontroller serial port, you can not go through M A X232 chip!
9. The open area effective transmission distance of 10 meters, over 10 meters are possible, but do not guarantee the quality of the connection
10. After the pairing is successful, can be used as a full-duplex serial interfaces. Do not need to know any of the Bluetooth protocol, but only supports 8 data bits, 1 stop bit, no parity communication format. This is the most common communication format, not support other format!
11. Press the button to give the Bluetooth module is powered up can enter A T mode, set parameters and query information
12. You can switch between master and slave mode via A T commands
13. The module default baud rate is 9600, the default passkey is 1234, the default name for the H C-05
14. protection with transparent heat shrinkable tube
Package 1*bluetooth module,
6 set kable
|